|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
Filename: tfs 300.doc Version 1.6 17.05.2006 VI TELEFILTER Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: External Coil: 23 0 C dBm Filter specification TFS 300 1/5 607 || -1,7 pF 607 || -1,7 pF 122 nH Characteristics Remark: The reference level for the relative attenuation arel of the TFS 300 is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 300,0 MHz without any tolerance. The given values for both the relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data Insertion loss (reference level) Nominal frequency Centre frequency Passband Bandwidth 3 dB arel 600 13 kHz MHz ae fN fC PB BW typ. value 3,1 300,01 MHz fN tolerance / limit max. 6,5 300,00 70,0 kHz dB MHz 306 kHz min. 280 kHz Relative attenuation fN fN fN fN 400 400 600 100 kHz kHz ... fN kHz ... fN MHz 32 32 47 60 0,9 - dB dB dB dB s min. min. min. min. max. max. 15 27 35 58 2 13 dB dB dB dB s dBm Group delay ripple within PB Input power level Operating temperature range Storage temperature range Frequency inversion temperature Temperature coefficient of frequency TCf ** OTR + 20 -0.036 C ppm/K - 20 C ... + 80C - 30 C ... + 85C - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) f(Hz) = TCf(ppm/K2) x (T-T0)2 x fTo(MHz) Generated: Checked / Approved: Tele Filter GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 300.doc Version 1.6 17.05.2006 VI TELEFILTER Filter characteristic 0 -6 -12 -18 -24 -30 -36 -42 -48 -54 -60 295 Filter specification TFS 300 2/5 0 -4 -8 -12 -16 -20 -24 -28 -32 -36 -40 299.5 16.25 14.75 13.25 11.75 10.25 8.75 7.25 5.75 4.25 2.75 1.25 300.5 delay in s magnitude in dB magnitude in dB 296 297 298 299 300 301 frequency in MHz 302 303 304 305 299.6 299.7 299.8 299.9 300 300.1 frequency in MHz 300.2 300.3 300.4 Construction and pin connection (All dimensions in mm) 7 5 1 2 3 4 5 6 7 8 Output Ground External Coil Ground Input Ground Ground Ground 300 U20 1 3 1,8 Max. 0,64 Date cod e 1 5 - 0,10 + 0,15 3 120 1,1 2,54 50 Test circuit L1 0,1 7 5 Date code: U V W ... Year + week 2006 2007 2008 1,1 5 C1 1 L2 SAW C2 L3 2, 4, 6, 7, 8 3 Tele Filter GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 300.doc Version 1.6 17.05.2006 VI TELEFILTER Stability characteristics, reliability Filter specification TFS 300 3/5 After the following tests the filter shall meet the whole specification: 1. Shock: 2. Vibration: 3. Change of temperature: 4. Resistance to solder heat (reflow): 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 -55 C to 125C / 30 min. each / 10 cycles DIN IEC 68 part 2 - 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 - 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: Pull Off Direction 3000 min. 300 mm min. 500 mm min. 300 mm Tape (all dimensions in mm) W : 12,00 0,3 Po : 4,00 0,1 Do : 1,50 +0,1/-0 E : 1,75 0,1 F : 5,50 0,05 G(min) : 0,75 P2 : 2,00 0,05 P1 : 8,00 0,1 D1(min) : 1,50 Ao : 5,30 0,1 Bo : 5,30 0,1 Ct : 9,5 0,1 P1 Date Code t Do Po P2 E G Ct Bo F Ko Typ PIN Marker D1 Ao W2 Reel (all dimensions in mm) A : 330 W1 : 12,4 +2/-0 W2(max) : 18,4 N(min) : 50 C : 13,0 +0,5/-0,2 A C N W1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. G W Filename: tfs 300.doc Version 1.6 17.05.2006 VI TELEFILTER Air reflow temperature conditions Filter specification TFS 300 4/5 Conditions Average ramp-up rate (30C to 217C) > 100C > 150C > 217C Peak temperature Time within 5C of actual peak temperature Cool-down rate (Peak to 50C) Time from 30C to Peak temperature Exposure less than 3C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260C between 10 and 30 seconds less than 6C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / C max. 260C 217C max. 300 s 10 ... 30 s 30 ... 150 s Time / s Tele Filter GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 300.doc Version 1.6 17.05.2006 VI TELEFILTER History Version 1.3 Reason of Changes Filter specification TFS 300 5/5 Name Dr. Wall Date 28.03.2001 Add history. Change date code from month to week. Correct tape and reel information. Use harder test conditions for point stability characteristic. Use harder conditions for vibration and damp heat Add input power level Change operating temperature range and relative attenuation Add filter characteristic Add typical values 1.4 1.5 1.6 Herrler Strehl Dr. Wall 30.07.2001 15.05.2006 17.05.2006 Tele Filter GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. |
Price & Availability of TFS30006 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |